Node:Window-managers and ECB, Previous:Hide-show, Up:Tips and tricks
There are several window-managers available which offer an easy interface to jump between different window-configurations within the same frame. A window configuration is the layout of windows and associated buffers within a frame. There is always at least one configuration, the current configuration. You can create new configurations and cycle through the layouts in either direction. Window configurations are often named or numbered, and you can jump to and delete named rsp. numbered configurations.
Without special support by ECB these window-managers would not work in combination with ECB!
ECB currently supports the following managers:
IMPORTANT: With one of these window-managers installed and active you can run applications like Gnus, VM or BBDB in the same frame as ECB! Just use different window-configurations (winring.el) or escreens (escreen.el) for ECB and the other applications. Especially with winring.el you can give every configuration a descriptive name like "ECB" or "Gnus"; afterwards you can jump to a window-configuration by name!
The rest of this section describes how to enable the special ECB-support for these window-managers and how to use them.
Every support must be enabled explicitly:
ecb-winman-winring-enable-support. This MUST be done BEFORE the first call to any winring-command, so also before calling
ecb-winman-escreen-enable-support. This MUST be done BEFORE the first call to any escreen-command, so also before calling
If a window-manager-support should be enabled autom. after Emacs-start
just put the following into your
(ecb-winman-winring-enable-support) (winring-initialize) ;; or - if you like escreen more (ecb-winman-escreen-enable-support) (escreen-install)
After enabling the support of one of the supported window-managers just go on as described in the commentary or introduction of the respective library-file(s) of the window-manager. Here is a short description:
ecb-winman-winring-name. There is always only one window-configurations with name
winring-initialize. If ECB is active then the
resulting window-configuration is the ECB-window-configuration.
Otherwise you can create the ECB-window-configuration when you first
winring-new-configuration with name equal to
ecb-winman-winring-name. In general you can run all commands of
the winring-library. If you jump to the ECB-window-configuration then
ECB will be autom. activated and if you leave the
ECB-window-configuration then ECB will autom. deactivated.
ecb-winman-escreen-number. There is always only one escreen with number
escreen-install (deactivates ECB if currently
running). After that you can call
escreen-goto-screen1. These commands autom. activate ECB
if creating or selecting the escreen with number
ecb-escreen-number (default = 1) and autom. deactivate ECB if
leaving the ECB-escreen.
There is normally no need to do this but nevertheless it can be done
And of course all other